Installation

Lumeta PowerPly: Dramatic installation time and cost savings!

Lumeta PowerPly “Peel and Stick Solar” modules are simple to install, allowing a seamless application with most low slope roofing systems. This unique design means that there are no roof penetrations, no support rails, or any associated hardware needed to mount a conventional photovoltaic system. With Lumeta’s Building Integrated Photovoltaic solar modules installation time is reduced by 50%.  Here’s how easy it is to install:

  1. Mark the array with chalk lines prior to installation
  2. Peel the release paper off of the butyl adhesive and lower module
  3. Adhere module to roof, applying firm pressure with a broom
  4. Repeat steps 1 through 3 until all modules are installed
  5. Line up battens or Oly Blocks between junction boxes and thread wire
  6. Connect the wires to the junction boxes
  7. Complete electrical assembly as you would any PV system